Wheel Stand PokaPremium

Details

Several months of testing and several design modifications resulted in the highest quality product.

We present a stable and precisely finished wheel stand. A tool used to support work on rims or entire wheels.

Thanks to 3 rollers, we can turn the wheel in any direction without any problem.

The rollers can be set at an angle, supporting the wheel with bail or horizontally without the use of a bail.

This solution allows you to work on the rims according to your preferences and possibilities.

The stand is made of high-quality, durable 4mm black steel, precisely cut and bent, finally coated with a powder finish, both inside and outside, to provide an additional protective layer against oxidation.

Bottom rollers with a length of 300m and a top with a length of 400mm (total length of the bail is 900mm) will match the rims in size from 14 "to 22". High-quality rubber feet keep the stand in one position during all work.

Thanks to the special rear bends, the bail is very stable even with massive wheels.

The stand is ideal for:

- ceramic coating application

- wheel renovation

- polishing the rims

- painting rims

- cleaning rims

Dimensions:

Length - 59 cm

Width from the wall - 37 cm

Height - 92 cm

The powder the protective layer is resistant to moderate watering, however, if the protective the layer is damaged, the steel may corrode.

Therefore, we do not recommend filling the stand with heavy water, and after each possible flooding, it should be thoroughly dried